Search

The MT3608 is a compact, high-efficiency DC-DC boost (step-up) voltage converter. It takes a low input voltage and increases it to a higher, stable output voltage.Key FeaturesVoltage Boost: Converts low voltage (2V to 24V) up to a higher voltage (5V to 28V).Adjustable Output: Features an onboard mul..

Key attributesIndustry-specific attributesPhase2TypeHybridOther attributesPlace of OriginJiangsu, ChinaBrand NameDEWO MOTORModel NumberDW57HS82-4004Current / Phase4AProduct namecnc router nema 23 57hs82 stepper motor set with driver and controllerVoltage/Phase3VResistance/Phase0.75Ω..

This Mounting Bracket from EasyMech is designed for NEMA17 Stepper Motor to mount it on the application firmly and securely. The EasyMech Bracket for NEMA 17 Stepper Motor is made from high-quality Hardened Mild Steel.The Mounting Bracket is designed by EasyMech with one thing in mind, boosting the ..

This Mounting Bracket from EasyMech is designed for NEMA 23 Stepper Motor to mount it on the application firmly and securely. The EasyMech Bracket for NEMA 23  Stepper Motor is made from high-quality Hardened Mild Steel.The Mounting Bracket is designed by EasyMech with one thing in mi..

DescriptionFour wire motor joint plug DuPont 4Pin terminal 6pin motor lineMotor insertion line length 2 metersMotor line 4, the new upgrade, with 4 jumpers and line, to avoid disorderly line, not easy to finish...

A4988 Stepper Motor Driver Module with Heatsink is a breakout board microstepping driver with translator and overcurrent protection. This stepper motor driver controls one bipolar stepper motor at up to 2 A output current per coil i.e., in full-, half-, quarter-, eighth-, and sixteenth-step modes, ..

This driver uses Infineon chips BTS7960 composed of high-power drive full H-bridge driver module with thermal over-current protection. Double BTS7960 H-bridge driver circuit, with a strong drive and braking, effectively isolating the microcontroller and motor driver! High-current 43A Specifica..

Product Introduction – DM542 Digital Stepper DriverThe DM542 is a reliable and high-performance digital stepper motor driver, designed to control 2-phase and 4-phase hybrid stepper motors with precision. Supporting a wide range of input voltages (18–50VDC) and output currents (up to 4.2A), it provid..

DRV8825 Stepper Motor Driver with Aluminum Heat Sink is a carrier board or breakout board for TI’s DRV8825 stepper motor driver; we therefore recommend careful reading of the DRV8825 datasheet before using this product. This stepper motor driver lets you control one bipolar stepper motor at up to 2..

DescriptionProduct Descriptionthis is a high performance DC to DC step-down adjustable power supply module, switching regulator.Mode: LM2596S-ADJInput voltage: 3.2-40VOutput Voltage: 1.5-35V (adjustable), input must least high 1.5V than outputOutput current: rated current 2A, maximum 3A (need to add..

Feature: On-board DIP switch, you can easily adjust the drive segments Terminal power connector for easy connection drive power Compatible with 12 / 24V drive scheme Suitable for 42 stepper motor drive, 3D printers and DIY Specification: Size: 42 x 42 x 15mm Fixed: 3mm Pitch: 1400 x 1400mil (35.56 ..